Concrete Contractors

Bollard Installation

Several steps must be followed to ensure a safe installation when installing a bollard. These include securing the installation site and obtaining the necessary permits. Once the site is secure, you should clean and mark the surface for the bollard. You should then use a drill to make a hole four inches bigger than the bollard’s diameter. The hole should also leave two inches of wiggle room around the bollard.

Concrete Contractors

Bollard Installation Edmonton is a relatively simple process that requires little expertise or tools. The main requirement is that you should be able to install the bollard securely. Once you have the necessary tools for the job, you should carefully handle it so that the piece does not break during installation. Once the installation is done, you should place a protective covering to protect it from debris. You can also place duct tape on the hole to keep it clean.

When installing a bollard, it is important to remember that the ground sleeve must be level and flush with the ground. If the pillars are surface-mounted, the ground sleeve should be about 36 inches above the ground and level. The ground sleeve must be cured before installation.

Before installing a pipe bollard, you must clean the concrete surface thoroughly. If necessary, use a pressure washer or blow-out pump to remove any debris that may have accumulated. Also, make sure to vacuum the site thoroughly. Once the surface has been cleaned, you can start installing the pipe bollard. When installing a pipe bollard, make sure to follow local building codes. If your bollard is placed incorrectly, the building codes may not allow it to remain in place. If the installation is not done properly, the city may deem the bollard as a public safety hazard and require removal.

There are several types of materials that are used for bollards. The materials used for these devices are usually recyclable. For example, polyethylene is environmentally friendly, and you can find rustproof polyurethane bollards. They are also durable and UV resistant. Some bollards even have reflective tape to provide maximum visibility. This is ideal for areas where a high visibility bollard is essential.

The location of a bollard is also a major factor. Depending on the area, the location can be an alley, a parking lot, or a driveaway. Bollards can provide security and traffic control for a property and add a touch of class to any building. Some modern designs feature a satin finish, while others have a more classical look.

The cost for bollard installation varies considerably. It can range anywhere from $800 to $1275 for a single bollard, with lower quantities costing less than $700. In addition to the installation itself, different specifications will influence the price. For example, installing bollards before paving the area would save you money by not having to cut the asphalt.

Another important aspect of bollards is their ability to resist impact forces. These security devices are generally made of steel and concrete and come in different sizes. You should choose the appropriate size for the area and the speed range of the vehicles passing through it. Lastly, the height and width of the security barriers should be considered when selecting a bollard.

Usually, bollards are installed in rows. The distance between two bollards should be at least three feet apart. This distance is necessary for wheelchairs and other motorized chairs to maneuver. However, this distance may vary depending on the location of the bollards and on the requirements of the project.

Bollards are often installed to protect the perimeters of buildings. They also serve as a visual guide for vehicles, and help to secure buildings. They are typically made of durable materials, such as concrete filled steel. Bollards may be permanent fixtures or can be removable to suit the needs of the property owners. The most common materials for bollards are metal, stone, and cement. In some cases, they also serve dual functions, including blocking vehicles from entering an area and blocking them from exiting.